Press "Enter" to skip to content

Cutting machine safety operation procedures


customized metal cutting disc

1 Wear work clothes and protective equipment such as protective glasses before work.
2 Before starting, first check whether the customized metal cutting disc and its protective device are in good condition.
3 When using the cutting piece to polish the workpiece, first start to be idling normally, then take it from light to heavy, and evenly force. But the pressure should not be too large or violent to bump, so as not to cause the cutting piece to rupture and hurt people.
4 Do not grind heavy, too large, too long or too small, too thin workpiece on the cutting piece. It is not allowed to stand on the front of the cutting piece.
5 It is forbidden to open the cutting piece casually or hit the cutting piece with the impact of the object. When changing the cutting piece, check the cutting piece for cracks or defects. When loading, pay attention to correcting, ensure that the cutting piece is not eccentric. When you are looking for the right time, you should use a wooden device to gently tap it. Do not use too much force and do not use metal to beat. If the fit is appropriate, it should be flattened and the unqualified cutting piece should not be used.
6 After the cutting piece is thinned and ground, it should be replaced in time. Thickness or size can be based on experience to ensure safety.
7 The cutting machine should have a person responsible for maintenance and management, and non-designated personnel are not allowed to adjust or install the cutting piece.
The power cord and plug of the 8-hand cutting blade must not leak electricity. The length of the cord should be appropriate, and it should not be too long to bend. Turn off the power immediately after use, do not open the cutting blade to leave to do other work.
9 The power switch should be installed near the worker to stop in time in the event of an accident.
10 Personal and equipment accidents occur, protect the scene and report to relevant departments in a timely manner.

Be First to Comment

Leave a Reply

%d bloggers like this: